ENGINEERING & DESIGN
We collaborate with our valued clients in all aspects of proper design and implementation as required by federal, state, and local regulations as well as individual company procedures and practices.
Automation and ControlS
- Cause and Effect Diagrams
- Control Narratives
- Interconnects
- Programmable Logic Controller (PLC) Sizing
Civil / Structural
- Foundations
- Geotech Coordination and Analysis
- Pipe Supports and Spans
- Primary and Secondary Containment Design and Calculations
- Storage Tanks – Oil, NGLs, Fresh and Produced Water
- Structural Steel
ELECTRICAL
- Distribution Sub Stations
- Electrical Studies: Load Flow, Protective Device Coordination, Short Circuit, and Arc Flash Hazard Analysis
- Emergency Generation and Power Back-Up System Engineering and Design
- Grounding Design
- Hazardous Area Classification
- Heat Trace Design Coordination
- Industrial Power Distribution System Engineering and Design
- Instrumentation Design
- Lighting
- Motor Starter, Soft Start, and VFD Sizing and System Integration
MECHaNICAL
- Central Delivery Points (CDPs) and Separation
- Compressor, Pump, Meter, and Regulator Stations
- Gas and Liquids Modeling / Analysis
- Gas Processing
- Gas Treatment
- High / Low Pressure Pipeline Gathering, Transmission, and Distribution Systems
- Natural Gas Gathering and Storage Fields
- Pipeline Launchers and Receivers
- Renewable Natural Gas (RNG)
- Transmission, Gathering, and Distribution Pipelines
- Well Connections
Mechanical, Electrical, Plumbing
- COMcheck Energy Compliance Documentation
- Domestic Potable Water Systems and Sanitary Sewer Systems
- Equipment and Duct Layouts
- Heating, Ventilation, and Air Conditioning Systems (HVAC)
- Interior and Exterior Lighting and Control Systems Design
- Major Renovations
- Natural Gas and Compressed Air Piping Systems
- New Construction
- Power Distribution Systems: Industrial, Commercial, Residential
- Process Piping Systems
- Tenant Remodels
- Utility Coordination
- Value Engineering
MODELING PROGRAMS
- AutoCAD®
- Autodesk® Civil3D®
- Autodesk® Plant 3D®
- AutoPIPE
- CADWorxs®
- E-TAP
- Pipeline Compliance System
- Symmetry (Pipe, Process, and Flare)
PROJECT MANAGEMENT
Full spectrum of services from project initiation, planning, execution, monitoring and controlling to closing.
ENGINEERING & DESIGN
Experienced staff and latest modeling software allow for state of the art engineering support and design.
